Computer Graphics Display Output: graphics driver conflict. An incompatible graphics driver fails to initialise the intended display mode.

The distinguishing clue

Video works during startup but fails after the graphics driver loads or changes.

Checks before an assessment

Record the affected display, port, resolution and refresh rate. Compare a known cable and display if the connectors are sound; stop load tests if excessive heat accompanies artefacts.

Stop point: Stop high-load testing if artefacts are accompanied by excessive heat or burning smell.

Workshop confirmation and repair

Device-level check: Compare another cable and display, inspect temperatures and separate software from hardware rendering.

Targeted check: Compare the exact graphics hardware, supported driver and last working configuration. If confirmed: Restore the supported graphics driver or roll back the confirmed change.

Repair boundary: Repair driver state or the confirmed graphics card, connector or board path.

Related cause to rule out

When one connected screen is blank while another active display shows the desktop, also consider Computer Graphics Display Output: display output selection before choosing a repair.

Checks after the work

After repair or replacement, check native resolution, multiple outputs, video playback, graphics load and restart.

For an AEPC repair assessment in East Auckland, provide the exact model and observed clue. Call 027 908 8880 before visiting the Burswood workshop.